SpinTrak Rotary Control Spinner
Stock Level: 5
$81.67 CAD

SpinTrak Rotary Control Spinner:

Two modes of operation:

Can be used as a lightweight Super High Resolution Low-Inertia Trackwheel control as used in "Arkanoid"

Can also be used as a spinner with the addition of one of two sizes of fly-weight to provide inertia giving long spin-times of up to 20 seconds.

Correctly-designed flywheels with mass concentrated at the larger radius. Ultra-high resolution. Unbeatable 1200 pulses per revolution.. Super-tough quality. Unit is manufactured by a supplier of encoders for high-speed motor usage and is almost identical to their industrial unit. Dual sealed ball-bearing races give the ultimate in smooth control. One-Piece bearing housing/body CNC machined from a solid alloy billet Available in two versions, for direct connection to USB, or for connection to our Opti-PAC or Mini-PAC interfaces. In USB mode, this is the worlds only USB 2.0 spinner.

USB 2.0 enables a 16-bit interface and a faster packet-rate than USB 1.1 Vital to avoid slowdown or backspin. Usage not limited to gaming! Also suitable for precision control applications, CNC interfacing and other rotary measurement applications. Spinner Knob Sold SeparatelyConnection to Mini-PACThe Mini-PAC wiring harness is supplied with an adaptor header. The connection from the harness to the SpinTrak should look like this:spinner connection to minipacConnection to Opti-PACFor Opti-PAC connection, the 4-pin connector fitted to the device must be cut off and the wires stripped back. They are connected as follows: Brown +5Volts Yellow X1 Green X2 White GND Connecting Mouse ButtonsMouse buttons are connected to 3 pins on the header as shown in the picture below.The COM connection of both switches should be connected to COM and the normally-open connection of each switch to the LEFT or RIGHT pin.spinner buttonsDimensionsspintrak dimension


  • 1x SpinTrak Rotary Controller Spinner